devices.esphome.io

Ilonda Wifi Smart Fish Feeder (L88)

Ilonda Wifi Smart Fish Feeder (L88)

Device Type: misc
Electrical Standard: global
Board: esp8266

Ilonda Wifi Smart Fish Feeder (L88) is a Tuya-based device sold by Amazon (not only under Ilonda, but also under other brand names).

image

Originally intended to be used with its companion app, once flashed using tuya-convert, ESPHome generated firmware can be uploaded allowing you to control the Wifi Smart Fish Feeder via Home Assistant.

Configuration

Thanks to the amazing Tasmota template, managed to build a fully working esphome configuration. This assumes you have a secret.yaml with ssid and password keys.

esphome:
  name: wifi_smart_fish_feeder


esp8266:
  board: esp01_1m


wifi:
  ssid: !secret wifi_ssid
  password: !secret wifi_password


logger:


api:


ota:


# Binary Sensor to allow relay to be switched when physical button is pressed
binary_sensor:
  - platform: gpio
    id: button
    pin:
      number: GPIO4
      mode:
        input: true
        pullup: true
      inverted: True
    name: 'Switch feeder'
    on_press:
      - switch.turn_on: relay


  - platform: status
    name: "Status"


switch:
# Switch to turn feeder on for 3 seconds/off and turn on/off LED
  - platform: gpio
    name: 'Relay feeder'
    id: relay
    pin: GPIO14
    on_turn_on:
      - light.turn_on: led
      - delay: 3s
      - switch.turn_off: relay
      - light.turn_off: led
    restore_mode: ALWAYS_OFF


sensor:
# Feeder counter
  - platform: pulse_meter
    pin: GPIO12
    name: 'Counter/min'
    unit_of_measurement: 'time(s)'
    internal: true
    total:
      unit_of_measurement: 'time(s)'
      name: 'Counter feeder'


# To allow led to be controlled via GPIO
output:
  - platform: esp8266_pwm
    id: blue_led
    pin:
      number: GPIO5
      inverted: true


# LED control
light:
  - platform: monochromatic
    output: blue_led
    id: led

You can now add your Wifi Smart Fish Feeder to Home Assistant via the configurations page, look for \'ESPHome\' under the Integrations option and click \'Configure\'.

See Also

Edit this page on GitHub

On this page